install/ build front driveshaft install front axle shafts/ hubs
I would like to build a skidplate if anyone has a large piece of 1/4 or 3/16 plate laying around
install/ build front driveshaft install front axle shafts/ hubs
I would like to build a skidplate if anyone has a large piece of 1/4 or 3/16 plate laying around
Originally Posted by afroman006Originally Posted by afroman006
Flemco 60
Final stance
Please ingnore that the wheels don't match I will paint them soon
Originally Posted by afroman006Originally Posted by afroman006
Looks awesome Creighton! What did your wheelbase come out to be?
BDR
its like 107ish"
drives great but fully hydro is touchy, which is nice but takes a while to get used to over sloppy steering
Originally Posted by afroman006Originally Posted by afroman006
Built some tube fenders this weekend I think they came out pretty good and should hold up a lot better than the sheetmetal
Cut 3 inches out of the hood
still need to smooth them out a little and paint and add hood latches back
Last edited by AggieTJ2007; 04-11-2010 at 08:21 PM.
Originally Posted by afroman006Originally Posted by afroman006
Yes they do
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
I just fixed them I think I might make some for the back so the tires don't throw quite so much mud
Originally Posted by afroman006Originally Posted by afroman006
do you plan on attaching them to the front grill hoop?
I thought about attaching them to the grill hoop and I might but then it would be hard to take them off
Originally Posted by afroman006Originally Posted by afroman006
Well motor doesn't seem to be too bad off, lots of mud in cylinders 1 and 2
no bent/broken valves and nt bent/broken rods should run once I get it all clean and put back together
Last edited by AggieTJ2007; 12-19-2010 at 08:33 AM.
Originally Posted by afroman006Originally Posted by afroman006