Beast from da Middle East

[85cj7]

What are the valves for? fuel cutoff?

It's a tap to turn off the gay, hopefully someone hits it soon.

[tommy53002]

btw, I was thinking about using a valve like that as a rear line lock. Good or bad idea?

[agjohn02]

bad

[Shaggy]

Doubt it would hold

[tommy53002]

bad

Care to explain? I would prefer to stay away from the $$$$ electric ones.

[85cj7]

$35 too rich for your blood? If so might want to get out of the hobby!
http://www.spidertrax.com/s.nl;jsess...2&category=215

[tommy53002]

$35 too rich for your blood? If so might want to get out of the hobby!
http://www.spidertrax.com/s.nl;jsess...2&category=215

That is doable, but if a sub $10 valve would work

[eight]

The 044 pump operates at 70+ PSI, and Ed's truck has an external regulator on it.

The pump operates at whatever pressure you set the regulator at. That's what a pressure regulator does, it regulates pressure. You use it in a bypass setup, think of it like a relief valve. I doubt yall would have deviated very far from the factory pressure set point, which is less than 15 psi.

[BMFScout]

looks like some janky brass ball valves and nice fittings?

[agjohn02]

looks like some janky brass ball valves and nice fittings?

i've always told people that that jimmy brune fellow was very observant.

[BMFScout]

I don't understand what it's for?

[robertf03]

http://www.summitracing.com/parts/CTR-24-260/

[robertf03]

There is no high pressure, it's less than 15 psi. This is assuming it still uses the stock tbi built in regulators. I slip a hose over it and use a hose clamp.

1/2" line, 3/8" barb. That hasn't worked

[Sharpe]

btw, I was thinking about using a valve like that as a rear line lock. Good or bad idea?

Uhh...brake operate at ~1500 PSI. ****ty home depot ball valve will not hold. Get a Jegs house brand line lock, you dont even need a relay!

[DRAGOONRANCH]

btw, I was thinking about using a valve like that as a rear line lock. Good or bad idea?

Best Idea Evarh!!!