I am running Chevy DLEs on all 4 of my joints. I have a hi-steer passenger knuckle, so I have a drag link from the pitman to the hi-steer part of the knuckle and then I have a tie rod connecting the two knuckles. For some reason I used the weaker DLEs. I have bent several of these already.

I now have in my possession 1 Chevy K30 TRE. It is short and threaded all the way to the tapered shaft. It has a 1" threaded shaft. I realize that I can use the stock K30 drivers side TRE(the long pice that spans the length of the frontend) and a stock connecting sleave, but I would rather run this thick ass DOM that I have.

How do I connect this TRE with a 1' threaded shaft to my DOM with a 1" ID?

Is there a TRE like the one I have, but LH thread?

Confused yet?