-
Regsitered Uesr
1/4" or 3/8" plate
Anybody have some 1/4" or 3/8" plate they aren't using? Preferably in the CS area. Trying to get a new skid built for the toy before tcc.
Does Mack carry plate?
Or I could use some 1/4"x 5 or 6" flat bar.
-
dyskrasia
yes, all the steel places should carry plate, though they may want you to buy an entire sheet
-
D-FENS
bryan iron and metal has mill plate cheap in 3/16" and 1/4". all the steel i have used on the jeep has come from there. you do not want to pay for regular plate. it is expensive.
-
Regsitered Uesr
What's mill plate?
I actually only need like 5" wide strips, so I might just get some 1/4"x5" flat is Mack carries that.
-
Teaching America's youth
its cut up plate thats left over from mill work, there are some pretty big sheets out there. last i checked it was $.30/lb
Ryan Clarke
(214)695-7901
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules