Working on this project has been alot nicer since I have a garage now. I have the floor pans replaced and welded up. It was a ton of work to put these guys in I am never doing that again. I need to put down some seam sealer and then coat of the rest of the cab with POR15 and it should be good to go.
Next will be the wiring harness. I have a 4 wheel junky kit. It was about 1/3 cost of a painless kit.
Plumb up the fuel lines from my old bronco and install my 24 gallon tank and she should be running again.
My garage it beginning to look like karls. I need to clean up a bit.
Also the door striker post is a sweet ground clamp.