Beast from da Middle East

[DRAGOONRANCH]

those shocks are $100 each Ed

they better be some panty droppers for that much....

[DRAGOONRANCH]

**** To Do List:

• Mount Radiator (either build better mount for existing radiator, or install newish aluminum radiator and get new fan. leaning towards just building a good mount for the existing one)
• Replace bolts for front of bed.
• Mount rock ring outter on H1's up front.
• Install tunes.
• Flush diffs, install new diff covers, fill with fluid and repair breather tubes.
• Finish up cutting brakes.
• Install rock lights.
• Get exhaust redone.
• Replace front windshield (not a necessity at this time, but it is getting pretty close to being pretty fubar'ed).
• Groove boggers.
• Install 2nd propane tank mount and cut sight hole in side of bed.
• Clearance rear fenders.
• Build tube tailgate and skin with original tailgate.

If I make it into TTC, it will need waterproofing (snorkel and distributor) plus a 15/16.5k lb winch (which will need to be hard mounted instead of on the cradle like the 9.5ti I have now)

[DRAGOONRANCH]

**** To Do List:

• Mount Radiator (either build better mount for existing radiator, or install newish aluminum radiator and get new fan. leaning towards just building a good mount for the existing one) (1-2 hours)
• Replace bolts for front of bed. (.5 hour)
• Mount rock ring outter on H1's up front. (.5 hour)
• Flush diffs, install new diff covers, fill with fluid and repair breather tubes. (ruffstuff covers :check: )(1 hour)
• Finish up cutting brakes. (1 hour)
• Install rock lights, turn/brake/running lights. (jcwhitney for turn signal :check: )(3 hours)
• Get exhaust redone. (1 hour)
• Groove boggers. (will probably do up there)
• Install 2nd propane tank mount and cut sight hole in side of bed. (.5 hour)
• Clearance rear fenders. (.5 hour)
• Mount winch (1/2 day w/ radiator mounting)

just cleaning up the list of **** to do.

Parts:
Turn signal switch
Diff Cover Bolts
Muffler pipe
Winch hardware (clamps, clevis/hook, lug for end of wire rope)

[DRAGOONRANCH]

Who's got my brake line flare tool?

**** To Do List (updated AGAIN!) :

• New Master Cylinder for brakes and plumb in 2nd line lock(or at least get them bled long enough to install hydroboost)
• Install new clutch slave and bleed
• Install new fan belt
• Reseal diff covers
• Replace bolts for front of bed. (.5 hour)
• Groove boggers.
• Clearance rear fenders.
• Mount front tires on recentered rims.

just cleaning up the list of **** to do.

Parts Needed:
Diff Seals
Rope thimble for 7/16" wire rope