6 should be fine
6 should be fine
Originally Posted by afroman006Originally Posted by afroman006
I'm pretty sure I saw 5k and other stuff available at Smiley's, and then there is the one with the knob that plugs into the same port.
Or you could ditch the loincloth and club and let the computer control the rev limit
...
if i'd known it was going on ugly i coulda just sold you some of this
you can get different RPM modules from 3000-12000rpm in 100rpm increments
http://store.summitracing.com/egnsea...00122+%2D98388
Last edited by rockfrawg; 06-24-2008 at 03:53 PM.
http://www.corral.net/tech/powerplant/arm/
"Desired RPM = (resistance in ohms) + 1000"
...
If you buy those chip sets from Summit, I may buy 1 or 2 from you that you don't need.
A 5k or something close would be perfect.
sweet thanks
Garrett you should be alright with the 'pane but here's some MSD/22re tech:
http://www.pirate4x4.com/forum/archi.../t-436107.html
Guess I need a tach adapter...looks like it's just a transformer. Flem, got instructions for how to make one of those?
Yea, I found that article on the install on pirate, don't know if that's the same one, but the one I saw was the cleanest Toyota engine bay I've ever seen.
I haven't purchased the tach adapter yet and I'll wait to see if I'm going to keep the runner before I order and install either.
did you get it yet?
i halfway remembered something last nite about the proper spark plug wires...there was a big warning somewhere that said "DO NOT USE WITH SOLID CORE WIRES"...might double check what you've got