I was about to say, its a janky idea at best, whatever you are doing.
I was about to say, its a janky idea at best, whatever you are doing.
Boats and hoes
Stumble in to the liquor store
With a dollar-fifty for a bottle of wine,
I know just what I'm lookin for
Thunderbird will do just fine.
heat was not so good on karls gas tank jb weld repair.
He who dies with the most **** wins, after seeing your collection you are in the lead no doubt!
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
Cracked the aluminum lower intake plenum on my crewcab's go-fitty-fo. A new one is $450 (A&M cost...) and I have no desire to remove the intake to have the crack TIG'd until absolutely neccesary. The crack is about an inch long starting at a threaded hole and coolant seeps through it fairly rapidly. I got some leak stopper from napa called Dike and it stopped the leak within about 10 minutes of driving. Made it all the way to Houston and back today and still no leaks so I'd say its good to go. I put some JB weld on top of the crack just for good measure yesterday while the motor was hot before the trip and will concur that yes, its viscosity goes to **** when hot. Oh well, problem solved...for now...
On the 8th day god created the Super Swamper TSL and said "go forth and kick ass"
anyone else had this problem with heims?
the heims for my steering ram are 5/8 and the bolt was a tight fit when i put in on. (both heims)
right before i loaded it on the trailer at trees i noticed a little play in the steering wheel.
i took out the bolt from the ram and there is a good 1/4 play from side to side between the bolt and the ID of the heim.
i will take it off again later and get a picture, but both heims were exactly the same way.
the bolt still fits in the tabs perfectly so the wear is in the heims themselves
WTF???
cheap heims?
sound like it or they got stretched
Originally Posted by afroman006Originally Posted by afroman006
I have the PSC ones, and still no play in them. Maybe somebody took your good ones and swapped in their wore ones to be super cheap???
i have psc one too and no play, i would call/e-mail psc and see what they say about them
5/8 is the size of the ID of the heim (size of the bolt) the thread should be a 3/4 x 16 ( i think )
no it is not sitting on threads.
guess i could go bigger but its going to suck drilling out those holes with a hand drill now.
i looked on the PCS website and i could not find replacement heims to find out what brand they were.
I would call up PSC first, they always seem to have outstanding customer service and may make it right for you. Can you mic the bolt and the heim to see where the actual play is?
im interested in how this works out because I will be running the same setup
Originally Posted by afroman006Originally Posted by afroman006