Quote Originally Posted by Hot Pocket View Post
a monoblock amp is an amp with only one set of outputs. if that is a 2 channel amp, you don't want to bridge it. Bridging it will present a 4 ohm load on the amp, and you will have about half the power as you would running it at two ohms. If the amp is two ohm stable, just run it red-red black-black, red-red black-black.

let's make this easier. what kind of amp are you using, i can draw you a sweet paint diagram
Huh? So you are saying bridging the channels, thus reducing resistance will cut your power output? Go re read your physics book.

Travis find out what the amp is stable at then wire you voice coils and amp to match. Wiring them in parallel will be have the ohms of one coil, in series will add the ohms together. Then run to the amp. Same thing goes for the amp outputs, bridged will reduce ohms at the amp. Too little resistance gives you a lot of bang but can over heat your amp.