Did you rebuild the cluster yourself? It turned out good.
Did you rebuild the cluster yourself? It turned out good.
I have a running/driving truck again, well kinda.
Rebuilt rear suspension, rear Eaton HO72 axle, and 2 piece driveshaft (new u-joints and center support bearing).
Repainted the upper dash black and the dash face a matching interior grey. Also replaced the light switch, dimmer floor switch, ignition switch, cigarette lighter and the rebuilt instrument cluster with working lights.
New battery box and hold down. All new wiring harness for the entire truck. New battery cables and grounds. New voltage regulator and resistor. New paper element air filter.
1. Wire you up an inverter.
2. Plug in Hairdryer and duct tape to intake
3. ????
4. Profit! (i.e. instant boost!)
leafblower
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
That thing is in serious need of some more paint in the engine bay and some cloth style wire loom.
"You know, this car is so fast, that giving Corvette owners this car, is kinda like giving an AK-47 to a pysch ward."
-Ron Fellows (Corvette C6R Team Driver)
lots of progress. keep it up
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
Somehow I missed this until now.
Is the bear? Is the guy?
I don't understand why you would use seam sealer in the middle of a panel. If you are worried about the weld area being sealed, you should use a poly primer, or an epoxy coating.
"You know, this car is so fast, that giving Corvette owners this car, is kinda like giving an AK-47 to a pysch ward."
-Ron Fellows (Corvette C6R Team Driver)
Where are you moving?
On the 8th day god created the Super Swamper TSL and said "go forth and kick ass"
I was wondering about the seam sealer, too. I'm no expert so I didn't say anything. Figured you had researched it somewhere.
Seth Stewart '04
2000 Suburban DD
1995 F150 SAS - Needs more work to sell
1998 GMC pickup - sold
2003 Yukon XL - wrecked/motor donor
1975 Scout - TBD
1976 Scout - parts truck
1972 IH 1310 dually - TBD
196? Scout 800 - 302 roller
MUCHO BUENO! That is starting to look like a truck again!
"You know, this car is so fast, that giving Corvette owners this car, is kinda like giving an AK-47 to a pysch ward."
-Ron Fellows (Corvette C6R Team Driver)