Also need to figure out the most efficient way to remove burnt rubber from the rear wheel wells. This and the bent body mounts lead me to believe the PO liked to party. I don't really want to burn it off due to the smell and mess and the wire wheel is taking too damn long. Also need to order .023 wire rollers for my Miller 210. I was telling Ryno about warping the floor on the passenger side floor smd he recommended switching to .023 wire for all the sheet metal work. I bought the wire and tips planning on just running the current .030 liner but I didn't think about the damn rollers. Tried it tonight with the .023 wire running through the .030 rollers and it worked *ok*. I offset one of the rollers a bit which helped but I still need to get the .023 ones. They are $40, which sucks.