I just have the 1st roll developed so far, finished product and testing pics will be up soon.
...and the transformation begins...
I just have the 1st roll developed so far, finished product and testing pics will be up soon.
...and the transformation begins...
Last edited by BigRedFord04; 08-02-2002 at 11:26 PM.
the TTB starts to go away
and its off!!
nekkidness!
still workin, late into the nite
...the penis ring just above his hand is where the driveshaft rubbed the exhaust occassionally
Last edited by BigRedFord04; 08-02-2002 at 11:40 PM.
rear axle (almost) out
4 tires replaced w/ 4 jackstands
(the next day)
shackle flip complete
*the pile of crap in the background is the TTB
Last edited by BigRedFord04; 08-02-2002 at 11:37 PM.
our workplace
closeup of the new coils next to the old
nix still pretending to work...4" blocks installed w/ re-geared 8.8" and RS5012s.
last one for now...nix using the "specialty" tool to finish removing the steering, an 1 7/8" wrench lovingly known as "the big tool" or "thaxton" for short
What kind of setup are you going for up front? 3link? 4link?
I am ready to start tearing mine apart, just need to get it up to CS somehow
92 YJ
04 F-150 4x4
11 F-250 4x4
i dont know what kinda "link" it is...factory radius arms from a `79 bronco w/ 7 degree C-Bushings on the axle...2 on each side...4 total?? i used the `95 radius arm mounts but moved them back 4" b.c. the older arms are longer. nix was kind enough to shave the body mount so they'd fit correctly and then the radius arm and body mount were welded together. I'll add a pic of that to the roll i need to finish for developing.