Where you working?Originally Posted by colman
So I can make sure and not take my car to them! Congrats.
Where you working?
So I can make sure and not take my car to them! Congrats.
He who dies with the most **** wins, after seeing your collection you are in the lead no doubt!
i didnt know that was job qualifications of a hr consultant?!?
its a summer job. i still haven't graduated.... maybe in december. (enter perpetual student joke.....)
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
So where are you working?
BDR
galleria area. place called herr schmidt at richmond and hilcroft
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
wave hi to all the stinky indians for me!
i grew up right there, in Briarmeadow
92 YJ
04 F-150 4x4
11 F-250 4x4
http://sanantonio.craigslist.org/pts/1883898070.html
Get this for him so he can link it.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
i thimk he may have something up his sleve....
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
well i worked on it today and got the 60 back under it by using a ubolt instead of the two studs in the housing, if anyone else is planning this fix you will need a 5 inch ID u bolt
now i just have to figure out all of the other little stuff to fix to get it back on the trail......
Brian did you notch the webbing or drill it near the tube and run it through? Also, how long was it? Or do you have a part number for it so I can get the guys at Heitman to find it much easier.
He who dies with the most **** wins, after seeing your collection you are in the lead no doubt!
Pictures damnit!
My bitch better have my money...
Through rain, sleet, or snow...
My whore better have my money...
Not half, not some, but all my cash...
'Cause if she don't,
I'm gonna put my foot in her ass.
here is what it ended up looking like, i didnt make it back out to my ranch today but should be getting some pics brought back to me tomorrow.
frick-the ubolt measured 5/8"x5"x~13"(i did cut off about 2 inches of the thread on each side once i installed it so you could go shorter), there isnt a part number for the ubolt as they make them custom for you while you wait, i waited for maybe 5 minutes for it to be made,
here are some pictures of how i did mine, all i still have to do is modify the spring plate
It might be the angle, but, can you get the diff cover off?
Posting Permissions
Reply With Quote